Users Guide

Command History
Version 9.0.2.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Example
Dell#show running-config acl
!
ip access-list extended ext-acl1
!
ip access-list standard std-acl1
!
ipv6 access-list Acl1
description IPV6 Access-list
seq 5 permit ipv6 1111::2222/127 host 3333::1111 log count bytes
remark 10 Remark for Entry # 10
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 100 count
Dell#
test cam-usage
Verify that enough ACL CAM space is available for the IPv6 ACLs you have created.
Syntax
test cam-usage service-policy input input policy name linecard {number |
all}
Parameters
policy-map name Enter the name of the policy-map to verify.
number Enter all to get information for all the linecards, or enter the linecard number to
get information for a specic card. The range is 0-6 for E-Series and 0-7 for C-
Series.
Defaults none
Command Modes EXEC Privilege
Command History
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series and E-Series TeraScale.
Usage Information
This command applies to both IPv4 and IPv6 CAM Proles, but is best used when verifying QoS
optimization for IPv6 ACLs.
924
IPv6 Access Control Lists (IPv6 ACLs)