Users Guide

• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
Related Commands hash-algorithm ecmp – changes the hash algorithm across an ECMP.
management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet | fortyGigE
| vlan | gigabitethernet | tengigabitethernet} command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prex format) of the
destination subnet.
ipv6-address prex-
length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prex format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prex length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
forwarding-router-
address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format)
of a forwarding router.
managementethern
et
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv4 Routing
871