Users Guide

tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the route. The
range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use this VRF option
after the next hop to specify which VRF the next hop belongs to. This setting is
used in route leaking cases. Refer to the Route Leaking VRFs section in the Virtual
Routing and Forwarding (VRF) chapter of the Conguration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination
address and not for the route pointing to destination a interface.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was
2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Using the following example of a static route: ip route 33.33.33.0 /24 tengigabitethernet 1/1 172.31.5.43
• The software installs a next hop that is not on the directly connected subnet but which recursively
resolves to a next hop on the interface’s congured subnet. In the example, if tengig 1/1 has an ip
address on subnet 2.2.2.0 and if 172.31.5.43 recursively resolves to 2.2.2.0, Dell Networking OS installs
the static route.
• When the interface goes down, Dell Networking OS withdraws the route.
IPv4 Routing
867