Users Guide
speed
Set the speed of a Fibre Channel port or congure the port to auto-negotiate its speed with a peer.
S5000
Syntax
speed {auto | 2G | 4G | 8G}
Parameters
auto The port autosenses the speed of a peer FC port .
2G Port speed is 2 gigabits per second (Gbps).
4G Port speed is 4 Gbps.
8G Port speed is 8 Gbps.
Defaults An FC port autosenses the speed of a peer FC port.
Command Modes INTERFACE FIBRE_CHANNEL
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information
When an FC port autosenses the speed of a peer FC port, it auto-negotiates to determine its speed.
To removed the congured port speed, enter the no speed {2G | 4G | 8G} command.
Example
Dell(conf)#interface fibrechannel 0/11
Dell(conf-if- fc-0/11)#speed 8g
Related Commands
interface brechannel — congures a Fibre Channel interface on the switch.
show interfaces brechannel — displays the conguration of a Fibre Channel interface.
Passthrough Commands
The following are passthrough commands supported on the S5000.
show stack-unit port-group portmode
Display the bre channel port-group mode information.
S5000
Syntax
show system stack-unit unit-number port-group portmode
Parameters
stack-unit unit-
number
Enter the keywords stack-unit then the unit number. The range is from 0 to 11.
Fibre Channel Interface Commands
825