Users Guide

25
Fabric Services Commands
The following commands are supported for Fabric Services operation on the S5000.
active-zoneset
Activate the zoneset.
S5000
Syntax
active-zoneset zoneset_name
To change to the default zone behavior, use the no active-zoneset zoneset_name command.
Parameters
zoneset_name Enter the zoneset name.
Command Modes FC FABRIC CONFIGURATION
Command History
Version 9.1(1.0) Introduced on the S5000.
Example
Dell(conf)# fcoe-map default_full_fabric
Dell(conf-fcoe-default_full_fabric)# fc-fabric
Dell(conf-fmap-default_full_fabric-fcfabric)# active-zoneset zs1
Related Commands
show fc zoneset — displays the congured and active zoneset.
change fc-trace-level
For debugging purposes, change the FC trace level used to record FC information in the trace log.
S5000
Syntax
change fc-trace-level number
Parameters
number Trace level used to record FC information in the dump le. Range: 1 to 4, where:
• 0 turns FC traces o.
• 1 records FC error messages.
• 2 records FC warning messages.
• 3 records FC informational messages.
802
Fabric Services Commands