Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related Commands
interface ManagementEthernet — congures the Management port on the system (either the Primary or
Standby RPM).
duplex (10/100 Interfaces) — congures duplex mode on physical interfaces with the speed set to 10/100.
management route — congures a static route that points to the Management interface or a forwarding
router.
stack-unit portmode
Split a single 40G port into four-10G portsConvert a single 100G port into one 40G port, or four 10G, 25G, or two 50G, or one 40G
ports.
S5000
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identier of the stack member to reset.
number Enter the port number of the 40G port to be split.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on
the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
778
Interfaces