Users Guide

Vlan membership:
Vlan 2, Vlan 20
Native VlanId: 20
Name: TenGigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/4
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Related Commands
interface — congures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces transceiver — displays the physical status and operational status of an installed transceiver.
The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.
S5000
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/port]
transceiver
Parameters
tengigabitethernet For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
fortyGigE For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
NOTE: This command also enables you to view information corresponding
to a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is dierent from how
you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Interfaces
767