Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For VLAN interfaces, enter the keyword vlan followed by a number from 1 to
4094.
NOTE: This command also enables you to view information corresponding
to a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is dierent from how
you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/
[subport] - slot/port/[subport]. For example, if you want to
display information corresponding to all ports between 1 and 4, specify the
port range as show interfaces interface-type 1/1/1 -
1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Added support to display the interface congurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale. Prior releases supported
2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show interfaces description command shown in the Example below.
Interfaces
761