Users Guide

State
Te 3/2 Up 0 0 20 800 4500 120
Te 3/10 Up 0 0 5 750 2500 20
Dell#
Related Commands
dampening — congures dampening on an interface.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces congured — displays any interface with a non-default conguration.
show interfaces phy
Display auto-negotiation and link partner information.
Syntax
show interfaces gigabitethernet slot/port phy
Parameters
tengigabitethernet Enter the keyword tengigabitethernet then the slot or port information.
NOTE: This command also enables you to view information corresponding
to a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is dierent from how
you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Added support to display the interface congurations corresponding to a range of
ports.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
758
Interfaces