Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-gi-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specic physical interface or virtual interface.
S5000
Syntax
show interfaces interface-type slot/port/
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
• For stack-units, enter the keywords stack-unit then the slot/port
information.
•
For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
Interfaces
749