Users Guide

full Enter the keyword full to set the physical interface to transmit in both directions.
Defaults Not congured.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information This command applies only to management interfaces with speed set to 10/100 Mb/s using the speed
command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the duplex command.
Related Commands interface ManagementEthernet — congures the Management port on the system (either the primary or
standby stack-unit).
owcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig ports.
Syntax
flowcontrol rx {off | on} tx {off | on} [negotiate]
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received ow control frames on this
port. This is the default value for the receive side.
rx o Enter the keywords rx off to ignore the received ow control frames on this
port.
tx on Enter the keywords tx on to send control frames from this port to the connected
device when a higher rate of trac is received.
tx o Enter the keywords tx off so that ow control frames are not sent from this
port to the connected device when a higher rate of trac is received.
Defaults
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
724
Interfaces