Users Guide

Parameters
milliseconds Enter the interval in milliseconds. The range is from 100 to 65535. The default is
1000 milliseconds.
Defaults 1000 milliseconds
Command Modes INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information This last-member-query-interval is also the interval between successive Group-Specic Query messages. To
change the last-member-query interval, use this command.
ip igmp snooping mrouter
Statically congure a VLAN member port as a multicast router interface.
S5000
Syntax
ip igmp snooping mrouter interface interface
To delete a specic multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
710
Internet Group Management Protocol (IGMP)