Users Guide

ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
S5000
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval command.
Parameters
seconds Enter the number of seconds between queries sent out. The range is from 1 to
18000. The default is 60 seconds.
Defaults 60 seconds
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Maximum range of the Hello interval value is changed to 18000. Introduced on the
S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to
act as an IGMP Proxy Querier.
E-Series legacy
command.
Usage Information If you have congured the hello interval value to be greater than 18000, you must rst reset that value to be
less than or equal to 18000 before upload. Otherwise, the command execution fails during bootup and the
hello interval value is set to the default value.
698
Internet Group Management Protocol (IGMP)