Users Guide

dcb-map stack-unit all stack-ports all
Apply the specied DCB map on all ports of the switch stack.
S5000
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no dcb-map stack-
unit all stack-ports all command.
Parameters
dcb-map-name Enter the name of the DCB map.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information The dcb-map stack-unit all stack-ports all command overwrites any previous DCB maps
applied to stack ports.
Related Commands dcb-map – creates a DCB map to congure PFC and ETS parameters and applies the PFC and ETS settings
on Ethernet ports.
show qos dcb-map
Display the DCB parameters congured in a specied DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters congured in the specied map.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
9.3(0.0) Introduced on the FC Flex IO module installed in the MXL 10/40GbE Switch.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and priority-
based ow control (PFC) parameters used to congure server-facing Ethernet ports. S5000 Ethernet ports
are DCBx-enabled by default.
580
Data Center Bridging (DCB)