Users Guide

F-Application priority for FCOE enabled
f-Application Priority for FCOE disabled
I-Application priority for iSCSI enabled
i-Application Priority for iSCSI disabled
-----------------------------------------------------------
Interface TenGigabitEthernet 0/49
Remote Mac Address 00:00:00:00:00:11
Port Role is Auto-Upstream
DCBX Operational Status is Enabled
Is Configuration Source? TRUE
Local DCBX Compatibility mode is CEE
Local DCBX Configured mode is CEE
Peer Operating version is CEE
Local DCBX TLVs Transmitted: ErPfi
Local DCBX Status
-----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
dcb-map
Create a DCB map to congure priority ow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that
support converged Ethernet trac. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults None. There are no pre-congured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes CONFIGURATION
INTERFACE
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information
A DCB map is a template used to congure DCB parameters and apply them on converged Ethernet
interfaces. DCB parameters include priority-based ow control (PFC) and enhanced trac selection (ETS).
576
Data Center Bridging (DCB)