Users Guide
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any conguration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress (Conguration)
Select the FP groups for CAM access control lists for Layer 2, IPv4, and IPv6 ACLs.
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl number}
Parameters
default Reset the egress CAM ACL entries to the default settings.
l2acl number
ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM prole name followed by the amount of CAM space to be allotted.
The total space allocated must equal 13. The l2acl range is 1 to 4. The ipv4acl range
is 1 to 4. The ipv6acl range is 0 to 4.
Command Modes CONFIGURATION
Command History
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
You must save the new CAM settings to the startup-cong (write-mem or copy run start) then
reload the system for the new settings to take eect.
There are four groups total. You must allocate at least one group for L2ACL and IPv4 ACL.
The range for the CAM proles are 1 to 4 for l2acl. The range for the ipv6acl prole is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
534
Content Addressable Memory (CAM)