Users Guide
Related Commands reload type — Congure the reload mode as Normal or BMP.
stop jump-start
To prevent an innite loop, stop the switch from reloading in BMP mode.
Syntax
stop jumpstart
NOTE: This command has been deprecated. It has been replaced by the stop bmp command.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Deprecated command. Replaced by the stop bmp command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced for the S4810.
Usage Information Use the stop jumpstart command on a switch running BMP 2.0 if the switch enters a loop while
reloading in jumpstart mode; loop occurs when the switch is continuously trying to contact a DHCP server
and a DHCP server is not found. The stop jumpstart command stops the switch from connecting to
the DHCP server. After you use the
stop jumpstart command, the next default reload type is a normal
reload. This is indicated in the show reload-type command.
Related Commands reload type — congures the reload mode as normal or jumpstart (BMP).
Bare Metal Provisioning (BMP)
529