Users Guide

redistribute ospf
Redistribute OSPF routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]]
[route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
process-id Enter the number of the OSPF process. The range is 1 to 65535.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF
external routes. You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of a
congured route map.
Defaults Not congured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version Description
9.2(1.0) Introduced on the Z9500.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage Information
When you enter the redistribute isis process-id command without any other parameters, Dell
Networking OS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This
feature is not supported by an RFC.
This feature is not supported by an RFC.
show ip bgp ipv4 multicast
View the current MBGP routing table for the system.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast [detail | network [network-mask] [length]]
Parameters
detail (OPTIONAL) Enter the keyword detail to display BGP internal information for
the IPv4 Multicast address family.
502
Border Gateway Protocol