Users Guide

capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both | rx |
tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not congured.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced.
Related Commands
capture bgp-pdu max-buer-size — species a size for the capture buer.
show capture bgp-pdu neighbor — displays BGP packet capture information.
clear ip bgp
Reset BGP sessions. The soft parameter (BGP Soft Reconguration) clears the policies without resetting the TCP connection.
S5000
Syntax
clear ip bgp [vrf vrf-name] [* | <1–4294967295> | <0.1–65535.65535> |
A.B.C.D {soft {in | out}} | X:X:X:X::X {soft {in | out}} | dampening |
flap-statistics | ipv4 | ipv6 | peer-group]
Border Gateway Protocol
393