Users Guide
Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
mac access-group
Apply a MAC ACL to trac entering or exiting an interface. You can apply a MAC ACL on a physical, port-channel, or VLAN
interface.
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-name command.
Parameters
access-list-name Enter the name of a congured MAC access list, up to 140 characters.
vlan vlan-range (OPTIONAL) Enter the keyword vlan and then enter a range of VLANs. The
range is from 1 to 4094 (you can use IDs 1 to 4094).
NOTE: This option is available only with the keywordin option.
in Enter the keyword in to congure the ACL to lter incoming trac.
out Enter the keyword out to congure the ACL to lter outgoing trac.
NOTE: The option is not available on the S-Series.
NOTE:
1. If the MAC ACL is applied on VLAN, none of the VLAN members should have an access list applied
for that VLAN.
2. If the MAC ACL is applied on a Physical or Port Channel interface, the VLAN in which this port is
associated should not have an access list applied.
3. If the MAC ACL is applied on a VLAN, then that VLAN should not belong to VLAN ACL group.
4. If the MAC ACL is applied on a VLAN ACL group, then none of the VLANs in that group should have
an access list applied on it.
Defaults
none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
Access Control Lists (ACL)
251