Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
Usage Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the o-line diagnostics complete. This reboot is an automatic process. A warning
message appears when the offline stack-unit command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot after
completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Buer
Tuning Commands
The following sections detail the buer tuning commands.
WARNING: Altering the buer allocations is a sensitive operation. Do not use any buer tuning commands without rst
contacting the Dell Networking Technical Assistance Center (TAC).
buer-prole (Conguration)
Create a buer prole that can be applied to an interface.
Syntax
buffer-profile {fp | csf] profile-name {global {1Q | 4q}
Parameters
fp Enter the keyword fp to create a buer prole for the Field Processor.
csf Enter the keyword csf to create a buer prole for the Switch Fabric Processor.
prole-name Create a name for the buer prole,
global Apply one of two pre-dened buer proles to all of the port-pipes in the system.
1Q Enter the keyword 1Q to choose a pre-dened buer prole for single queue (for
example, non-QoS) applications.
4Q Enter the keyword 4q to choose a pre-dened buer prole for four queue (for
example, QoS) applications.
Defaults Dynamic
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Debugging and Diagnostics
1927