Users Guide
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that
are up and congured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface reload, the system waits
300 seconds (5 minutes) to bring up VRRP on that interface.
For the delay timers to take eect, save the conguration and reload the system.
Related Command vrrp delay minimum — sets the delay time for VRRP initialization after a line card reboot.
vrrp-group
Assign a VRRP ID to an interface. You can congure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information The VRRP group only becomes active and sends VRRP packets when you congure a virtual IP address.
When you delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related Command virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
1916
Virtual Router Redundancy Protocol (VRRP)