Users Guide

stack-unit stack-group
Congure a stacking group specied by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
To remove the current stack group conguration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.10.2 Introduced on the S4810.
Usage Information
WARNING: The following message displays to conrm the command: All non-default
configurations on the related member ports ports (<ports listed here>)
will be removed. Do you want to continue (y/n)? If you enter “y”, all non-default
congurations on any member ports of the current stack group are removed when you reboot the
unit.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
1854
VLAN Stacking