Users Guide

upgrade system (stack unit)
Upgrade the Dell Networking OS image on one or all stack units in an S5000 stack from the master switch.
S5000
Syntax
upgrade system {flash://file-path | ftp://file-path | scp://file-path |
tftp://file-path | usbflash://file-path} | stack-unit {stack-unit—id | all}
{A: | B:}}
Parameters
boot Enter the keyword system to change the Dell Networking OS image.
ash: After the keyword flash:, enter the location of the source le in the internal ash
in the format: //file-pathname or press Enter to launch a prompt sequence.
ftp: After the keyword ftp:, enter the location of the source le in the format: //
userid:password@host-ipaddress/file—pathname or press Enter to
launch a prompt sequence.
scp: After the keyword scp:, enter the location of the source le in the format: //
userid:password@host-ip-address/file-pathname or press Enter to
launch a prompt sequence.
tftp: After the keyword tftp:, enter the location of the source le in the format: //
host-ipaddress/file-pathname or press Enter to launch a prompt
sequence.
usbash: After the keyword usbflash:, enter the location of the source le in the external
ash in the format: //file-path or press Enter to launch a prompt sequence.
le-path Enter the path and lename to be used to upgrade the Dell Networking OS image.
stack-unit {stack-
unit-id | all}
Enter the keyword stack-unit: followed by the stack unit ID of a member unit
or all to upgrade the boot image on all stack member units. Valid stack-unit ID
numbers are 0 to 11.
A: | B: Enter the Dell Networking OS partition to be upgraded with the new image.
Defaults None
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage Information You must reload Dell Networking OS after executing this command. Use the upgrade system stack-
unit command to copy Dell Networking OS from the management unit to one or more stack members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp://
userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp://
userid:password@hostip/filepath)
stack-unit: Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6, (tftp://hostip/filepath)
Dell#upgrade system ftp://username:password@10.11.1.1/FTOS-SH-9.0.1.3.bin
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Erasing Sseries ImageUpgrade Table of Contents, please wait
.!........................................................
Stacking Commands
1781