Users Guide

stack-unit stack-group
Congure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the
correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group conguration, use the no stack-unit unit-id stack-group
stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Usage Information The following message displays to conrm the command.
Setting ports Fo 1/60 as stack group will make their interface configs
obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-
default configurations on any member ports of the current stack group will
be removed when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking conguration process must be updated to
reect the Command Mode change from EXEC Privilege to CONFIGURATION to allow the scripts
to work correctly.
upgrade boot (stack unit)
Upgrade the boot image (bootash or bootselector) on one or all stack units in an S5000 stack from the master switch.
S5000
Syntax
upgrade boot {bootflash-image| bootselector-image} stack-unit {stack-unit—
id | all} {booted: | flash://file-path | ftp://file-path | tftp://file-path
| usbflash://file-path}
1778
Stacking Commands