Users Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related Commands
• reload – reboots Dell Networking OS.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-11 renumber 0-11
Parameters
0-11 The rst instance of this value is the stack member unit identier, from 0 to 11, of
the switch that you want add to the stack. The range is: 0 to 11. The second
instance of this value is the desired new unit identier number.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Usage Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered, only
that specic unit is reset and comes up with the new unit number.
Example
Dell#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related Commands
• reload – reboots Dell Networking OS.
• reset stack-unit – resets the designated S-Series stack member.
Stacking Commands
1777