Users Guide

show system stack-ports
Display information about the stacking ports on all switches in the stack.
Syntax
show system stack-ports [status | topology]
Parameters
status (OPTIONAL) Enter the keyword status to display the command output without
the Connection eld.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface
and Connection elds.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information The following describes the show system stack-ports command shown in the following example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone.
Interface The unit/port ID of the connected stack port on this unit.
Link Speed Link Speed of the stack port (10 or 40) in Gb/s.
Admin Status The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected.
Example
Example (Status)
Example (Topology)
Related Commands
• reset stack-unit – resets the designated stack member.
• show hardware stack-unit – displays the data plane or management plane input and output statistics of
the designated component of the designated stack member.
Stacking Commands
1775