Users Guide
Parameters
level Indicate a value from 0 to 7 or enter one of the following parameters:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series, S55.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information To block a type of message parameter, set the logging trap level to a lower number. For example, to block
severity messages at level 6, set the level to 5.
Related Commands
logging — enables the logging to another device.
logging on — enables logging.
show logging
Display the logging settings and system messages logged to the internal buer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse [number] |
summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the output. The range is
from 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only information in the Syslog
history table.
Simple Network Management Protocol (SNMP) and Syslog
1755