Users Guide

47
PIM-Source Specic Mode (PIM-SSM)
The protocol-independent multicast source-specic mode (PIM-SSM) commands in this section are supported in the Dell
Networking operating system.
IPv4 PIM Commands
The following commands apply to IPv4 PIM-SM, IPv4 PIM-SSM, and PIM-DM.
• clear ip pim tib
• debug ip pim
• ip pim dr-priority
• ip pim neighbor-lter
• ip pim query-interval
• show ip pim interface
• show ip pim neighbor
• show ip pim tib
IPv4 PIM-Source Specic Mode Commands
The following IPv4 PIM-source specic mode (PIM-SSM) commands are supported:
• ip pim ssm-range
• show ip pim ssm-range
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to specify
the SSM group range for that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and 3x/32
Command Modes CONFIGURATION
PIM-Source Specic Mode (PIM-SSM)
1461