Users Guide

46
PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating software on the platform.
The following describes the IPv4 PIM-SIM commands.
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim snooping tib
Clear tree information discovered by PIM-SM snooping from the PIM database.
Syntax
clear ip pim snooping tib [vlan vlan-id] [group-address]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to clear tree information base (TIB) information
learned through PIM-SM snooping about a specied VLAN. The valid VLAN IDs are
1 to 4094.
group-address (OPTIONAL) Enter a multicast group address in dotted decimal format (A.B.C.D) to
clear TIB information learned through PIM-SM snooping about a specied
multicast group.
Command Modes EXEC Privilege
Command History
Version Description
8.4.1.1 Introduced on the E-Series ExaScale.
8.3.21.0 Introduced on the S5000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related Commands show ip pim snooping tib – displays TIB information learned through PIM-SM snooping.
PIM-Sparse Mode (PIM-SM)
1427