Users Guide

show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address prex-
length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format then the prex length
in the /x format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
summary Display a summary of RPF routes.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
show ip bgp ipv6 unicast
View the current MBGP route table.
C-Series, E-Series, S4810
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
Paramters
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the keywords network mask (in slash prex format) of the
BGP network address.
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prex.
Command Modes
• EXEC
• EXEC Privilege
IPv6 Border Gateway Protocol (IPv6 BGP)
1051