Users Guide
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to send a log
message when the maximum value is reached. If this parameter is not set, the
router stops peering when the maximum number of prexes is reached.
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor next-hop-self
Allows you to congure the router as the next hop for a BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-group-name}
next-hop-self command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name (OPTIONAL) Enter the name of the peer group.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information If you congure the set ipv6 next-hop command in ROUTE-MAP mode, its conguration takes
precedence over the neighbor next-hop-self command.
1046
IPv6 Border Gateway Protocol (IPv6 BGP)