Users Guide

neighbor distribute-list
Distribute BGP information using an established prex list.
Syntax
neighbor {ipv6-address | peer-group-name} distribute-list prefix-list-name
{in | out}
To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-group-name}
distribute-list prefix-list-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group.
prex-list-name Enter the name of an established prex list. If the prex list is not congured, the
default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound trac.
out Enter the keyword out to distribute only outbound trac.
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related Commands
neighbor lter-list – assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map – assigns a route map to a neighbor or peer group.
neighbor lter-list
Congure a BGP lter based on the AS-PATH attribute.
Syntax
neighbor [ipv6-address | peer-group-name] filter-list aspath access-list-
name [in | out]
1044
IPv6 Border Gateway Protocol (IPv6 BGP)