Users Guide

routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible
routes.
received-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords received-routes then either the network
address (in dotted decimal format) or the network mask (in slash prex format) to
view all information received from neighbors.
NOTE: You must congure the neighbor soft-reconfiguration
inbound command prior to viewing all the information received from the
neighbors.
denied-routes
[network [network-
mask]
(OPTIONAL) Enter the keywords denied-routes then either the network
address (in dotted decimal format) or the network mask (in slash prex format) to
view all information on routes denied using neighbor inbound lters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast address families
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added the detail option. Output now displays the default MED value.
Version 7.2.1.0 Added the received and denied route options.
Version 6.3.10 The output is changed to display the total number of advertised prexes.
Usage Information The following describes the show ip bgp ipv6 unicast neighbors command shown in the
Example below.
Lines Beginning
With
Description
BGP neighbor Displays the BGP neighbor address and its AS number. The last phrase in the line
indicates whether the link between the BGP router and its neighbor is an external
or internal one. If they are located in the same AS, then the link is internal;
otherwise, the link is external.
BGP version Displays the BGP version (always version 4) and the remote router ID.
BGP state Displays the neighbor’s BGP state and the amount of time in
hours:minutes:seconds it has been in that state.
Last read This line displays the following information:
• last read is the time (hours:minutes:seconds) the router reads a message from
its neighbor
IPv6 Border Gateway Protocol (IPv6 BGP)
1025