Users Guide

show ip bgp ipv6 unicast
View the current BGP information.
Syntax
show ip bgp ipv6 unicast [network [network-mask] [longer-prefixes]]
Paramters
network (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP
network to view information only on that network.
network-mask (OPTIONAL) Enter the keywords network mask (in slash prex format) of the
BGP network address.
longer-prexes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a
common prex.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information When you enable the bgp non-deterministic-med command, the show ip bgp command output
for a BGP route does not list the INACTIVE reason.
show ip bgp ipv6 unicast cluster-list
View BGP neighbors in a specic cluster.
Syntax
show ip bgp ipv6 unicast cluster-list [cluster-id]
Paramters
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format.
Command Modes
• EXEC
• EXEC Privilege
1018
IPv6 Border Gateway Protocol (IPv6 BGP)