Users Guide

network backdoor
Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length backdoor command.
Parameters
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x
format. The range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information Though the system does not generate a route due to backdoor cong, there is an option for injecting/
sourcing a local route in presence of network backdoor cong on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually congured routes. These
routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name of an
established route map. Only the following ROUTE-MAP mode commands are
supported:
1012
IPv6 Border Gateway Protocol (IPv6 BGP)