Users Guide
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage Information Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer
group. Use this command with caution as it terminates the specied BGP sessions. When a neighbor or peer
group is shutdown, use the show ip bgp ipv6 unicast summary command to conrm its status.
Related Commands
show ip bgp ipv6 unicast summary – displays the current BGP conguration.
show ip bgp ipv6 unicast neighbors – displays IPv6 routing information exchanged by BGP neighbors.
neighbor soft-reconguration inbound
Enable a BGP soft-reconguration and start storing updates for inbound IPv6 unicast routes.
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor for which you want to start storing inbound
routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound
routing updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconguration for the specied BGP neighbor. BGP stores all updates for
inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session.
1006
IPv6 Border Gateway Protocol (IPv6 BGP)