Users Guide

Parameters

ipv6-address Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation species successive hexadecimal elds of zeros.

peer-group-name Enter the name of the peer group. All routers in the peer group receive routes from

a route reector.

Defaults Not congured and COMMUNITY attributes are not sent to neighbors.

Command Modes ROUTER BGP

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.4.2.1 Introduced on the C-Series and S4810.

Version 8.2.1.0 Introduced on the E-Series ExaScale.

Version 7.4.1.0 Introduced on the E-Series TeraScale.

neighbor shutdown

Disable a BGP neighbor or peer group.

Syntax

neighbor {ipv6-address | peer-group-name} shutdown

To enable a disabled neighbor or peer group, use the no neighbor {ipv6-address | peer-

group-name} shutdown command.

Parameters

ipv6-address Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation species successive hexadecimal elds of zeros.

peer-group-name Enter the name of the peer group to disable or enable all routers within the peer

group.

Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)