Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you use the no logging on command, messages are logged only to the console.
Related
Commands
logging – enables logging to the Syslog server.
logging buffered – sets the logging buffered parameters.
logging console – sets the logging console parameters.
logging monitor – sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
S5000
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-
interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For the management interface, enter the keyword
ManagementEthernet followed by the slot/port
information. The slot range is 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. The range is 1 to 128.
• For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
1214