Users Guide
S2(conf-if-vl-200)#ip address 10.10.1.2/24
S2(conf-if-vl-200)#tagged tengigabitethernet 12/4
S2(conf-if-vl-200)#vrrp-group 11
% Info: The VRID used by the VRRP group 11 in VRF 2 will be 178.
S2(conf-if-vl-200-vrid-101)#priority 255
S2(conf-if-vl-200-vrid-101)#virtual-address 10.10.1.2
S2(conf-if-vl-200)#no shutdown
!
S2(conf-if-te-12/4)#interface vlan 300
S2(conf-if-vl-300)#ip vrf forwarding VRF-3
S2(conf-if-vl-300)#ip address 20.1.1.6/24
S2(conf-if-vl-300)#tagged tengigabitethernet 12/4
S2(conf-if-vl-300)#vrrp-group 15
% Info: The VRID used by the VRRP group 15 in VRF 3 will be 243.
S2(conf-if-vl-300-vrid-101)#priority 100
S2(conf-if-vl-300-vrid-101)#virtual-address 20.1.1.5
S2(conf-if-vl-300)#no shutdown
VRRP for IPv6 Conguration
This section shows VRRP IPv6 topology with CLI congurations.
Consider an example VRRP for IPv6 conguration in which the IPv6 VRRP group consists of two routers.
NOTE: This example does not contain comprehensive directions and is intended to provide guidance for only a typical
VRRP conguration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to
support your own IP addresses, interfaces, names, and so on.
Virtual Router Redundancy Protocol (VRRP)
973