Users Guide

Congure RSTP on VLT Peers to Prevent Forwarding Loops (VLT Peer 2)
Dell_VLTpeer2(conf)#protocol spanning-tree rstp
Dell_VLTpeer2(conf-rstp)#no disable
Dell_VLTpeer2(conf-rstp)#bridge-priority 0
Conguring VLT
To congure VLT, use the following procedure.
Prerequisites: Before you begin, make sure that both VLT peer switches are running the same Dell Networking OS version and are
congured for RSTP as described in RSTP Conguration. For VRRP operation, ensure that you congure VRRP groups and L3
routing on each VLT peer as described in
VLT and VRRP interoperability in the Conguration Notes section.
To congure virtual link trunking and create a VLT domain in which two S5000 switches are physically connected and treated as a
single port channel by access devices, congure the following settings on each VLT peer device.
1. Congure the VLT interconnect for the VLT domain. The primary and secondary switch roles in the VLT domain are
automatically assigned after you congure both sides of the VLTi.
NOTE: If you use a third-party ToR unit, Dell Networking recommends using static LAGs on the VLTi between VLT
peers to avoid potential problems if you reboot the VLT peers.
2. Enable VLT and create a VLT domain ID. VLT automatically selects a system MAC address.
3. Congure a backup link for the VLT domain.
4. (Optional) Manually recongure the default VLT settings, such as the MAC address and VLT primary/secondary roles.
5. Connect the peer switches in a VLT domain to an attached access device (switch or server).
Conguring a VLT Interconnect
To congure a VLT interconnect, follow these steps.
1. Congure the port channel for the VLT interconnect on a VLT switch and enter Interface Conguration mode.
CONFIGURATION mode
interface port-channel id-number
Enter the same port-channel number congured with the peer-link port-channel command as described in Enabling
VLT and Creating a VLT Domain.
NOTE: To be included in the VLTi, the port channel must be in Default mode (no switchport or VLAN assigned).
2. Remove an IP address from the interface.
INTERFACE PORT-CHANNEL mode
no ip address
3. Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
• 10 Gigabit Ethernet: Enter tengigabitethernet slot/port.
• 40 Gigabit Ethernet: Enter fortygigabitethernet slot/port.
4. Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
5. Repeat Steps 1 to 4 on the VLT peer switch to congure the VLT interconnect.
902
Virtual Link Trunking (VLT)