Reference Guide

summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for up to seven stack members.
7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip cam command shown in the following
example.
Field Description
Destination Displays the destination route of the index.
EC Displays 1 if the route is an ECMP route. Else, displays 0.
C This is the CPU bit. If it displays 1, then it indicates that a
packet hitting this entry will be forwarded to the CPU.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 3 po 0 1.1.1.0/24 longer-prefixes
Destination EC C VId Mac-Addr Port
---------------------------------------------------------------
-----
1.1.1.2/32 0 0 3000 00:05:00:00:00:02 Te
3/44
974
IPv4 Routing