Reference Guide

Example
Dell#show hosts
Default domain is not set
Name/address lookup uses static mappings
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
Dell#
Related
Commands
traceroute — views the DNS resolution.
ip host — configures a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {id} [port-set {pipe-number} {ip-address
mask [longer-prefixes [ecmp-group detail]]}| ecmp-group {detail
| member-info [detail [group-index index-number]]}| summary]
Parameters
id Enter the stack-unit ID.
port-set pipe-
number
Enter the keyword port-set then the number of the stack
unit’s port-pipe.
network mask
[longer-
prefixes [ecmp-
group detail]]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. You can enter one of the
following keywords to filter results.
• Enter the keyword longer-prefixes to view routes
with a common prefix.
• Enter the keyword ecmp-group detail to view the
ECMP group index.
ecmp-group
{detail |
member-info
[detail [group-
index index-
number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
• Enter the keyword detail to view the ECMP group
index.
• Enter the keyword member-info to view the member
information for the ECMP group.
• Enter the keyword member-info detail to view
detailed ECMP membership and n-hop information.
• Enter the keyword group-index then the index number
to show ECMP membership per group. The range is from
0 to 1022.
IPv4 Routing
973