Reference Guide

ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables
command.
Defaults Disabled.
IPv4 Routing
963