Reference Guide

LinkFailures 0 TxOfflineSeq 3
InvalidCRC 0 TotalOfflineSeq 4
Rate info:
Input 0 bytes/sec, 0 frames/sec, 0.00% of line-rate
Output 0 bytes/sec, 0 frames/sec, 0.00% of line-rate
Time since last interface status change: 03:00:35
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
speed
Set the speed of a Fibre Channel port or configure the port to auto-negotiate its speed with a peer.
S5000
Syntax
speed {auto | 2G | 4G | 8G}
Parameters
auto The port autosenses the speed of a peer FC port .
2G Port speed is 2 gigabits per second (Gbps).
4G Port speed is 4 Gbps.
8G Port speed is 8 Gbps.
Defaults An FC port autosenses the speed of a peer FC port.
Command
Modes
INTERFACE FIBRE_CHANNEL
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When an FC port autosenses the speed of a peer FC port, it auto-negotiates to
determine its speed.
To removed the configured port speed, enter the no speed {2G | 4G | 8G}
command.
Example
Dell(conf)#interface fibrechannel 0/11
Dell(conf-if- fc-0/11)#speed 8g
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel
interface.
914
Fibre Channel Interface Commands