Reference Guide

Usage
Information
All Fabric-Services mode CLI commands are enabled after changing to Fabric-
Services mode.
When you run the fc switch-mode fabric-services command, the following
warning message displays:
• Warning!!: Switch mode in running-config will be changed to
'fabric-services' :Continue? [yes/no]:
– no – No effect on the running-config.
– yes – Changes the running-config to reflect the new switch-mode.
If an fcoe-map exists, the following warning message displays:
• Warning!!: Existing fabric configuration detected,
proceeding to REBOOT switch :Continue? [yes/no]:
– no – Does not reboot the switch.
– yes – Reboots the switch and prompts the user to save the running config.
If no fcoe-map exists, the switch-mode moves to the newly configured switch-
mode without any warning messages.
Example
Dell(conf)# fc switch-mode fabric-services
Related
Commands
show fc switch — displays FC switch parameters.
fc zone
Create a zone.
S5000
Syntax
fc zone zonename
To delete a zone, use the no fc zone zonename command.
Parameters
zonename Enter the zone name.
Command
Modes
CONFIGURATION
Command
History
Version 9.1(1.0) Introduced on the S5000.
Example
Dell(conf)# fc zone z1
Dell(conf-fc-zone-z1)#
892
Fabric Services Commands