Reference Guide

Related
Commands
tdr-cable-test — runs the TDR test.
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
• This feature is available only on the platform.
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast
command becomes ineffective on that interface.
• The existing show interface command has been modified to display the configured broadcast
address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
S5000
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Interfaces
883