Reference Guide

Version Description
8.4.1.0 Added support for port-channel interfaces (the port-
channel number option).
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Added the backup interface option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the
switchport command on the interface. To use the switchport command on an
interface, only the no ip address and no shutdown statements must be
listed in the show config output.
When you enter the switchport command, the interface is automatically added
to the default VLAN.
To use the switchport backup interface command on a port, first enter the
switchport command. For more information, refer to the “Configuring
Redundant Links” section in the “Layer 2” chapter of the Dell Networking OS
Configuration Guide.
Related
Commands
interface port-channel — creates a port channel interface.
show interfaces switchport — displays information about switchport interfaces.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
862
Interfaces