Reference Guide

1000 Enter the keyword 1000 to set the interface to auto-
negotiate its speed.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed.
Defaults auto
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with
the speed set to 10/100.
management route — configures a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
Syntax
stack-unit stack-unit port number portmode quad
Interfaces
859