Reference Guide

autoNegComplete field and the linkstatus field read
“True.”
AutoNegotiatio
n Advertise
Displays the control words the local interface advertises
during negotiation. Duplex is either half or full. Asym- and
Sym Pause is the types of flow control the local interface
supports.
AutoNegotiatio
n Remote
Partner’s Ability
Displays the control words the remote interface advertises
during negotiation. Duplex is either half or full. Asym- and
Sym Pause is the types of flow control the remote interface
supports.
AutoNegotiatio
n Expansion
ParallelDetectionFault is the handshaking scheme in which
the link partner continuously transmit an “idle” data packet
using the Fast Ethernet MLT-3 waveform. Equipment that
does not support auto-negotiation must be configured to
exactly match the mode of operation as the link partner or
else no link can be established.
1000Base-T
Control
1000Base-T requires auto-negotiation. The IEEE Ethernet
standard does not support setting a speed to 1000 Mbps
with the speed command without auto-negotiation. E-
Series line cards support both full-duplex and half-duplex
1000BaseT.
Phy Specific
Control
Values are:
• 0 - Manual MDI
• 1 - Manual MDIX
• 2 - N/A
• 3 - Auto MDI/MDIX
Phy Specific
Status
Displays PHY-specific status information. Cable length
represents a rough estimate in meters:
• 0 - < 50 meters
• 1 - 50 - 80 meters
• 2 - 80 - 110 meters
• 3 - 110 - 140 meters
• 4 - 140 meters
Link Status: Up or Down
Speed:
• Auto
• 1000MB
• 100MB
• 10MB
Interfaces
839